Selecting The Test Signal - Sony BVP-900 Series System Manual

In the camera select block, the MULTI indicator for
the master-designated camera lights in green and those
for the slave-designated cameras light in orange.
Camera select block
(Example: MSU-700A)
WAVEFORM MONITOR
PARA
MULTI
TALLY
PANEL
ACTIVE
1 2 3 4
EXPAND
When the setting is completed
Press the MULTI button so that it goes dark.
To cancel the master/slave designation
Press [Master] or [Slave] on the Master/Slave setting
display to set it to inverse video, then press the number
of the camera whose designation is to be canceled to
return it to its original state.
To make the settings from the RCP-720/
721/730/731/740/741
Press and light the MASTER button of the RCP-720/
721/730/731/740/741 for the camera to be designated
as the master unit. Press and light the SLAVE button
of the RCP-720/721/730/731/740/741 for the cameras
to be designated as the slave units.
Example:
RCP-740/741
MASTER button SLAVE button
LOCK
PARA MASTER SLAVE
When using the RCP-700/701, either the MASTER or
SLAVE indication lights in the camera number/tally
indication window of the RCP-700/701 depending on
the setting on the MSU-700A/750 or other RCP-series
panel. You can not specify the master/slave unit from
the RCP-700/701.
Camera number/tally indication window of the RCP-700/701
Example: when the MASTER
indication is lit
MULTI indicators
CC
5 6 7 8 9 10 11 12
CAM PW VF PW TEST1 TEST2 BARS
MASTER SLAVE
EXT

4-2-5 Selecting the Test Signal

You can select the test signal to be output from the
VBS1/VBS2/VBS3, WF1/WF2 OUTPUT, PIX1/PIX2
OUTPUT, and Y/R–Y/B–Y connectors of the CCU-
700A/700AP and the VBS1/VBS2/VBS3, WF
OUTPUT, PIX OUTPUT, Y/G, R–Y/R, B–Y/B
connectors of the CCU-550/550AP.
Press and light the desired signal output select button
on the MSU-700A/750 or RCP-720/721/730/731/740/
741. The signal generator of the camera is activated
and the selected signal is output.
Example: MSU-700A
Signal output select buttons
TEST: Signal selected on the MSU SW Setting
display (MSU-750 only)
For the MSU SW Setting display, see "3-4-4 Setting the
Operating Conditions of the MSU."
TEST1: Ramp waveform (gamma signal)
TEST2: Tri-level waveform or ten-step waveform
(RCP-740/741 and MSU-700A only. Select the
signal on the CAM Mode Setting display.)
For the CAM Mode Setting display, see "3-2-9 Initial
Settings of the Camera."
BARS: Color bar signal
Note
For the outputs from the CCU-700A/700AP/550A/
550AP, the BARS button takes priority over the other
two buttons. If the BARS button is lit, press the button
to turn it dark before pressing the TEST, TEST1 or
TEST2 button. (TEST, TEST1 and TEST2 have effect
on the viewfinder regardless of the BARS button
setting.)
TEST1 TEST2 BARS
4-27
Chapter 4 Adjustments