Sony BVP-900 Series System Manual page 57

2-1 Mounting the Video Camera
8
When the BKP-9057 viewfinder saddle is attached,
pull up the saddle and turn the saddle-locking knob
clockwise to secure the saddle.
9
Connect the remote cable of the CA-905F/905K to
the REMOTE connector on the rear of the CA-570/
570P.
Connect the CA cable of the CA-905F/905K to the
triaxial connector of the CA-570/570P.
Triaxial connector
CA cable
2-22
Chapter 2 Setup
Removing the camera
Note
If the BKP-9057 is attached, remove the viewfinder
first.
For details on removing the viewfinder, see "Attaching the
7-inch viewfinder" in "2-1-1 Mounting the BVP-900/900P."
If the BKP-9057 viewfinder saddle is attached, turn the
saddle-locking knob counterclockwise to loosen the
saddle, and pull down the saddle.
1
Remove the CA cable and remote cable from the
Saddle-locking
camera adaptor.
knob
2
Turn the lens-locking lever upward.
3
Slide the slide lever to LOCK.
Note
The lens cannot be removed unless the slide lever
is set to LOCK.
4
Remove the VF connector and the LENS
connector.
5
Push the safety lever and release lever to remove
the camera.
REMOTE
connector
Remote cable
Safety lever
Note
If, after removing the camera, the camera mounting pin
protrudes from the center of the lens attachment
section, it will not be possible to connect the camera to
the unit. If so, push the release lever while pushing the
safety lever.
Release lever