Sony BVP-900 Series System Manual page 303

5-4 Selecting and Modifying the Lens Files
To operate on the BVP-950/950P
When using the BVP-950/950P, select in advance the
file corresponding to the mounted lens.
For file selection, see "5-4-1 Selecting the Lens File
(BVP-950/950P)."
Use the ENTER/CANCEL switch, DISPLAY switch
and MIC1 LEVEL control.
Note
When the camera is installed in the CA-905F/905K,
use the rear control panel of the CA-905F/905K and
operate in the same manner as described for the BVP-
900/900P in the previous paragraph.
BVP-950/950P side panel
MIC1 LEVEL control
Inside the switch box
VTR
SEL
ENTER/CANCEL switch
DISPLAY switch
Operating procedure
1
While holding the ENTER/CANCEL switch
upwards to ENTER, set the DISPLAY switch to
MENU.
The Maintenance menu appears.
Maintenance menu
* Maintenance Menu *
System Setup
Reference Store
Lens File Store
OHB File Store
Auto Iris Setup
RPN Correct
29F040-BVP-900 X.XX
menu sel --> enter
5-18
Chapter 5 File Operations
GAIN OUTPUT AUTO WHITE
KNEE
STBY CAM
L ON B
M A
H PRE
SAVE BARS OFF SET
DISPLAY TESTOUT
ENTER ON ENC
OFF RGB
CANCEL MENU SEL
2
Move the cursor to "Lens File Store" by turning
the MIC1 LEVEL control, then press the control.
The Lens File Setup menu appears.
Lens File Setup menu
* Lens File Setup *
Lens File Store
Select Current Lens
Reset All Lens
Name :AB.5x5.5
No:1 EX1.0
The data in the current file are displayed.
Name: Name of the lens
No: Lens file number
EX: Lens extender value
F: Minimum f-stop
3
Operate the lens to turn off the lens extender.
4
Referring to Chapter 4, adjust the V modulation
shading, flare and white for R and B.
5
Check that the cursor is set at "Lens File Store" (if
not, move the cursor using the SET switch), then
depress the MIC1 LEVEL control.
6
Return the lens extender to the ON status and
adjust the V modulation shading flare and white
for R and B.
7
Check that the cursor is set at "Lens File Store,"
then press the MIC1 LEVEL control.
The file is changed according to the values
adjusted in steps 4 and 6, and the message
"Completed" is displayed.
To return the lens file to the factory settings
Move the cursor to "Reset All Lens," then depress
the MIC1 LEVEL control.
The factory settings are restored in all the lens
files.
8
When the change operation is completed, press the
ENTER/CANCEL switch downward to CANCEL
to return to the Maintenance menu.
To release the Maintenance menu
Return the DISPLAY switch to OFF.
F1.7