Allen-Bradley Powermonitor 3000 User Manual page 190

A-16 Powermonitor 3000 Data Tables
RS-232
Element Modbus Element name
No. Address
0 40401 Password
1 40402 Hardware port
2 40403 Protocol
3 40404 Delay
4 40405 Baud rate
5 40406 RS-232 address
6 40407 Data format
7 40408 Flow Control
(Handshaking)
8 40409 RTS On Delay
9 40410
10 40411
11 40412 Reserved
12 40413
13 40414
14 40415
15 40416
16 40417
17 40418
18 40419
19 40420
(1) The default address is the same as the 'Device ID', which is assigned at the factory and can be found printed on the white label on the side of the master module. The device ID is
incremented for each device.
Publication 1404-UM001D-EN-E - October 2004
Range Default Comment
Value
0 to 9999 0 Required to change configuration data. Returns -1
0 to 1 0 Select active port
0 = RS-232 port
1 = Native RS-485 port
0 0 0 = DF1 half-duplex slave
0 to 15 2 (10mS) Specifies the delay before responding to an external request.,
useful with slow external devices (such as RF modems)
0 to 4 3 0 = 1200 baud
1 = 2400 baud
2 = 4800 baud
3 = 9600 baud
4 = 19200 baud
1 to 254 (1) Identifies the device on the link. 0 is typically used by the DF1
master. 255 is the broadcast address
0 to 2 0 Parity, number of data bits, number of stop bits
0 = No parity, 8 data bits, 1 stop bit
1 = Even parity, 8 data bits, 1 stop bit
2 = Odd parity, 8 data bits, 1 stop bit
0 to 1 0 Data flow control for RS-232/RS-485 port.
0 = None
1 = Hardware RTS/CTS
0 to 9995 0
ms
Specifies the minimum delay between characters that indicates
the end of a message packet. 0 = 3.5 character times.
0 0 Reserved. Must be 0 on a write, returns 0