Allen-Bradley Powermonitor 3000 User Manual page 179

Remote I/O Discrete Data Accepted by Powermonitor (Master Output Data)
Element Element name
No.
1 Relay control
2 KYZ control
DeviceNet, EtherNet/IP and ControlNet I/O Data Provided by Powermonitor (Scanner Input Data; Instance 1)
Element Element name
No.
0 Relay output status
1 Solid-state KYZ output status
2 Alarm output word
3 Status inputs state
4 Status input #1 counter
5 Status input #2 counter
DeviceNet, EtherNet/IP and ControlNet I/O Data Accepted by Powermonitor (Scanner Output Data; Instance 2)
Element Element name
No.
0 Relay output
1 Solid-state KYZ output
Allen-Bradley HMIs
Range Comment
0 or 128 0 (Bit 8 = 0): De-energize
128 (Bit 8 = 1): Energize
Must be enabled by Control source parameter
Range Comment
0 to 3 0 = De-energized & not forced
1 = Energized & not forced
2 = Forced de-energized
3 = Forced energized
0 to FFFF Bitfield indicates state of 16 alarm output flags; 0 = released, 1 = asserted
Bit 0 = relay/setpoint output flag 1
Bit 1 = KYZ/setpoint output flag 2
Bit 2 = setpoint output flag 3
...
Bit 15 = setpoint output flag 16
0 to 3 Bit 0 = status input 1; 0 = open, 1 = contact closure detected
Bit 1 = status input 2; 0 = open, 1 = contact closure detected
Bit 2 = demand sync timeout; 1 = the demand delay expired before the next
expected external demand sync. This bit clears when the next external
demand sync occurs. Refer to Table A.6 Advanced Device Configuration
element 23.
Bits 3-15 = unused (always 0)
0 to Counts to 29,999, rolls over to 0.
29,999
Size and content of Instance 1 may vary depending
TIP
on user configuration. Refer to User-Configured Data
Table on page 4-53 for more information
Range Default Comment
Value
0 to 1 - 0 (Bit 8 = 0): De-energize
256 (Bit 8 = 1): Energize
0 to 1
Must be enabled by Control source parameter
Powermonitor 3000 Data Tables
Publication 1404-UM001D-EN-E - October 2004
A-5