Additional Powermonitor 3000 Ethernet Features; Sntp Client - Allen-Bradley Powermonitor 3000 User Manual

Additional Powermonitor
3000 Ethernet Features

SNTP Client

Allen-Bradley HMIs
Instance 1 ( EtherNet/IP DC Firmware )
Instance 1 represents the EtherNet/IP DC firmware. This instance
provides the mechanism for its update.
The Powermonitor 3000 system also supports a variety of other
Ethernet features.
The DC implements a Simple Network Time Protocol client in order to
provide a means for the Powermonitor 3000 system to receive
periodic updates to its system clock.
In order for the SNTP client to operate, there must be
TIP
access to an SNTP server.
Configuration Parameters
Before the SNTP Client can be initialized or run, it requires the
following three configuration parameters which are provided by the
host PM 3000 during initialization:
Table F.31 SNTP Client Configuration Parameters
Name
SNTP Server Address
Interval
Time Zone Adjustment
These configuration parameters are only passed to
TIP
the DC by the PM 3000 during initialization.
Consequently, changes to these parameters within
the PM 3000 will not take effect within the DC until
the next time it is reset.
Powermonitor 3000 EtherNet/IP Device Profile
Data Type
UDINT
UINT
INT
Publication 1404-UM001D-EN-E - October 2004
F-15