Configuring Setpoints - Allen-Bradley Powermonitor 3000 User Manual

Configuring Setpoints

Table 5.1 Setpoint Configuration
Parameter Name Parameter Description
Setpoint Number The number of the setpoint being configured.
Setpoint Type The parameter value to be evaluated by the
setpoint.
Setpoint Evaluation The operator used to evaluate the parameter
Condition value.
Setpoint High Limit The value being used as a reference to
activate the setpoint for over comparisons, or
to deactivate the setpoint for under
comparisons.
Note: This parameter is non-numeric when
viewed via the Display Module, and the
Setpoint Type is Phase Rotation or Status
input.
Allen-Bradley HMIs
Equal Setpoint
An equal setpoint activates when the monitored parameter equals the
Setpoint High Limit for a time greater than the Setpoint Action Delay.
An equal setpoint releases when the monitored parameter does not
equal the Setpoint High Limit for a period of time greater than the
Setpoint Release Delay. The Setpoint Low Limit is not used for equal
and not equal setpoints.
Not Equal Setpoint
A not equal setpoint is the opposite of an equal setpoint, activating
when monitored parameter does not equal the Setpoint High Limit for
a time greater than the Setpoint Action Delay. It releases when the
monitored parameter equals the Setpoint High Limit for a period of
time greater than the Setpoint Release Delay.
You may configure setpoints using the Display Module or by writing
the setpoint configuration table using communications. The following
tables describe setpoint configuration parameters.
Range
1 to 10 (M4, M5)
1 to 20 (M6, M8)
0 to 52 (Refer to Table A.19)
0 = Over forward (+)
1 = Over reverse (-)
2 = Under forward (+)
3 = Under reverse (-)
4 = Equal (=)
5 = Not equal (<>)
0 to 10,000,000
Setpoint Programming and Operation
Units
-
-
-
Depends on type
Publication 1404-UM001D-EN-E - October 2004
5-5
Default
N/A
0
0
0