Connection With N-Wire Type Emulator; Kel Connector; Figure 23-1: Connecting N-Wire Type Emulator (Ie-V850E1-Cd-Nw (N-Wire Card)) - NEC V850E/PH2 User Manual

23.2 Connection with N-Wire Type Emulator

To connect a N-Wire type emulator, it is necessary to mount an emulator connector and circuit for
connection on the target system.
Select either the KEL connector, MICTOR connector (Part number: 2-767004-2, distributor: Tyco
Electronics AMP K.K.), or 2.54 mm pitch 20-pin general-purpose connector as the emulator connector.
Connectors other than the KEL connector may not be supported, depending on the emulator, so when
using a connector, refer to the manual of the emulator used.

23.2.1 KEL connector

When the IE-V850E1-CD-NW is used, use of the following connector is recommended.
Part number
• 8830E-026-170S: Straight type
• 8830E-026-170L: Right-angle type

Figure 23-1: Connecting N-Wire Type Emulator (IE-V850E1-CD-NW (N-Wire Card))

Host machine
PCMCIA card slot
Chapter 23 On-Chip Debug Function (OCD)
IE-V850E1-CD-NW
User's Manual U16580EE3V1UD00
Connector for emulator
8830E-026-170S
Target system
979