Detecting Devices Connected To A Bridge Module (Nz2Aw1Gfal) - Mitsubishi Electric IQSS-R-E Reference Manual

Detecting devices connected to a bridge module (NZ2AW1GFAL)

To display devices supporting iQSS, which are connected to a bridge module (NZ2AW1GFAL), on a system configuration
diagram, first a bridge module (NZ2AW1GFAL) needs to be detected in the "CC IE Field Configuration" window. Then,
perform an automatic detection of connected devices in the "AnyWireASLINK Configuration" window in order to detect and
display devices supporting iQSS which are connected to a bridge module (NZ2AW1GFAL).
For the considerations when detecting devices supporting iQSS which are connected to a bridge module (NZ2AW1GFAL),
refer to the following section.
Page 103 Considerations when detecting devices connected to a bridge module
Operating procedure
1. Select
1. Select
5 CC-Link IE Field Network
102
5.1 Detecting Devices Supporting iQSS Automatically
2. Check
3. Click
2. Select
Select
1.
Detect and display a bridge module (NZ2AW1GFAL) in the
"CC IE Field Configuration" window.
For the method for detecting and displaying a bridge module
(NZ2AW1GFAL) automatically in the "CC IE Field Configuration"
window, refer to the following section.
Page 103 Detection method of a system configuration
2.
Select a bridge module (NZ2AW1GFAL) in 'List of stations' or
'Device map area' in the "CC IE Field Configuration" window,
and select [CC IE Field Configuration]  [Open System
Configuration]  [Open AnyWireASLINK Configuration].
3.
Select [AnyWireASLINK Configuration]  [Online]  [Detect
Now] in the "AnyWireASLINK Configuration" window.