Connecting sensor head to control module
The following describes the procedure to connect a sensor head to the control module.
Pay attention to the direction of a sensor head cable connector and insert the cable to the control module until it clicks.
Pull the cable lightly and check that it has been connected securely.
• When connecting one sensor head to the control module, connect the sensor head to the SENSOR HEAD A connector.
The measurement cannot be performed when the controller is connected to the SENSOR HEAD B connector.
• Do not mount the sensor head to the control module while the external power supply is turned on. Doing so may cause
sensor head failure.
• For details on connecting cables with sensor head fixed, refer to the following.
MELSEC iQ-R Laser Displacement Sensor Control Module User's Manual (Sensor Head)
6 INSTALLATION AND WIRING
6.2 Wiring Method