Ethernet (Error Codes Of Devices Supporting Iqss) - Mitsubishi Electric IQSS-R-E Reference Manual

Ethernet (Error codes of devices supporting iQSS)

An error code of a device supporting iQSS is displayed in the "Monitor Information" window of an engineering tool.
For details on the error, refer to the manuals of each device supporting iQSS.
Cognex Corporation
Error code Error and cause
0001H SLMP scanner is connecting.
0002H SLMP scanner connection was
rejected.
0003H SLMP scanning failed.
0004H The setting time of polling interval
is too short.
APPX
354
Appendix 5 Error Code List
Corrective action
Check the status of the SLMP scanner after wait several seconds and
the connection is established.
Check that the In-Sight camera is connected over the same port
number that the CPU module is accepting connections.
• Check if the network setting and configuration are correct.
• Check that the connection between devices is not disconnected.
Set the available time to the polling interval of the In-Sight camera.
Check on the Monitor
Information window of the
Sensor/Device Monitor screen.
Type/model name
■COGNEX Vision System
• In-Sight 5000
• In-Sight 7000
• In-Sight EZ-100
• In-Sight EZ-700
• In-Sight Micro