Data Restoration - Mitsubishi Electric IQSS-R-E Reference Manual

Data restoration

Information saved in an SD memory card can be restored to a device supporting iQSS for each station by using an
engineering tool.
Operating procedure
1. Select
2. Click
The initial value of the restoration setting (SD1444) is as follows:
• Lower 8 bits of SD1444 (operation setting on error): 0H (continue)
Use a program when restoring data with the settings other than above. (Page 87 Program execution for
data restoration)
■Data restoration method for a device supporting iQSS, which is connected to a bridge module
(NZ2AW1C2AL)
Data can be restored for a device supporting iQSS, which is connected to a bridge module (NZ2AW1C2AL), by the following
method.
Operating procedure
1.
Select a bridge module (NZ2AW1C2AL) in 'List of stations' or 'Device map area' in the "CC-Link Configuration" window.
2.
Select [CC-Link Configuration]  [Open System Configuration]  [Open AnyWireASLINK Configuration].
3.
Select [AnyWireASLINK Configuration]  [Online]  [Restore Slave Module] in the "AnyWireASLINK Configuration"
window.
When restoring data for a device supporting iQSS, which is connected to a bridge module (NZ2AW1C2AL), a
list of the backup data name (date_number) stored in the backup folder of CC-Link is displayed in the "Folder
Name" on the "Select Restoring Backup Data (AnyWireASLINK)" screen.
Backup data is stored in backup folders for each folder name (Station number/Station sub-ID number) in an
SD memory card.
For details on the backup folder configuration, refer to the following section.
Page 69 Backup folder configuration
4 CC-Link
86
4.5 Backing up/Restoring Data of Devices Supporting iQSS
2. Select
1. Select
1.
Select a target device supporting iQSS in 'List of stations' or
'Device map area' in the "CC-Link Configuration" window, and
select [CC-Link Configuration]  [Online]  [Restore Slave
Station].
2.
Select backup data to be restored, and click the [Execute]
button.
A list of the backup folder names (date_number) is
displayed in the column of "Folder Name".
Backup data is stored in backup folders for each
folder name (Start I/O number_Station number) in
an SD memory card.
For details on the backup folder configuration,
refer to the following section.
Page 69 Backup folder configuration
3.
Read the message, and click the [OK] button.
Data is restored.