Mitsubishi Electric IQSS-R-E Reference Manual page 203

■Setting the operation mode for CC-Link Ver.2-compatible slave station
A bridge module (NZ2AW1C2AL) is a CC-Link Ver.2-compatible slave station.
To detect and display a bridge module (NZ2AW1C2AL) on a system configuration diagram, set the operation mode in which
CC-Link Ver.2-compatible slave station works.
The following table shows the combinations of the parameter setting for a CC-Link master/local module and the CC-Link
operation mode for a bridge module (NZ2AW1C2AL).
CC-Link master/local module (RJ61BT11)
Parameter setting item
Mode
Remote net Ver.2 mode
Remote device net Ver.2 mode
For the information of the version and mode of CC-Link, refer to the following manuals.
MELSEC iQ-R CC-Link System Master/Local Module User's Manual (Application)
CC-Link-AnyWireASLINK Bridge Module User's Manual
Operating procedure
Station information (station type)
Ver.2 remote device station
1.
Detect and display a bridge module (NZ2AW1C2AL) in the
"CC-Link Configuration" window.
2.
Select the bridge module (NZ2AW1C2AL) and select [CC-
Link Configuration]  [Open System Configuration]  [Open
AnyWireASLINK Configuration] in the "CC-Link
Configuration" window.
Bridge module (NZ2AW1C2AL)
CC-Link operation mode
Ver.2.00
8.1 Detecting Devices Supporting iQSS Automatically
8
8 CC-Link
201