Table of Contents
Advertisement
Ethernet
Panasonic Industrial Devices SUNX Co., Ltd.
Type/model name
■Laser displacement sensor
• HL-C2
■Device supporting iQSS
• Page 332 Panasonic
Industrial Devices SUNX Co., Ltd.
Cognex Corporation
Type/model name
■COGNEX Vision System
• In-Sight 5000
• In-Sight 7000
• In-Sight EZ-100
• In-Sight EZ-700
• In-Sight Micro
■Device supporting iQSS
• Page 333 Cognex
Corporation
APPX
346
Appendix 4 Considerations for Using Device Supporting iQSS
Function
Automatic detection of connected
devices
Reflection of the communication setting
Status
Sensor/device monitor
Data backup/restoration
Function
Automatic detection of connected
devices
Reflection of the communication
setting
Sensor/device monitor
Consideration
Make sure whether the iQ Sensor Solution function is enabled on a target
device of the automatic detection function using the setting tool of HL-C2.
Setting a subnet mask and default gateway is required.
If the cells for subnet mask and default gateway setting are blank, the
communication settings can not be reflected.
The protocol is fixed to 'UDP'.
Do not configure the following IP addresses in the IP address settings.
An HL-C2 may not operate properly.
• 0.0.0.0
• *.*.*.0
• *.*.*.255
• 255.*.*.*
When the head unit is not connected to the controller, the unconnected flag is
set to the status.
To change the items to be monitored, use the application software
"Configurator WD" manufactured by Panasonic Industrial Devices SUNX
Co., Ltd.
When a timeout occurs, perform a data backup or restoration again.
If the problem persists, contact the manufacturer.
Consideration
Make sure whether the iQ Sensor Solution function is enabled on a target
device of the automatic detection function using the setting tool of COGNEX
Vision System.
Select 'TCP' for the protocol.
Set the IP address within the range from 1.0.0.1 to 223.255.255.254.
Do not make the host name a blank.
For usable characters to the host name, refer to the manuals of COGNEX
Vision System.
After completing the In-Sight job loading , perform the sensor/device monitor
function.
Advertisement
Table of Contents
