Mitsubishi Electric IQSS-R-E Reference Manual page 60

• Once an automatic detection of connected devices is performed, the mode setting and the transmission rate
which have been set in a CC-Link master/local module are also detected.
• The system configuration cannot be detected if an error occurs on the master station.
Take the corrective actions and perform an automatic detection of connected devices again.
• Error information is displayed in the "Output" window when an error occurred.
Double-click it and correct the error at the jumped destination.
• When a module which is not a device supporting iQSS is detected, it is displayed as shown below:
"Module with No Profile Found"
"General Module"
• When "Module with No Profile Found" is displayed, it can be changed to "General CC-Link Module" by the
following operation:
Select the target module, and select [CC-Link Configuration]  [Change Module]  [Change to General
CC-Link Module].
• When the automatic CC-Link startup is used, power OFF to ON or reset the CPU module after writing the
data to a CPU module. By performing automatic detection of connected devices again, the model name of a
slave station can be read.
For details on the automatic CC-Link startup, refer to the following manuals.
(MELSEC-Q CC-Link System Master/Local Module User's Manual)
(MELSEC-L CC-Link System Master/Local Module User's Manual)
■Detection methods of a system configuration
The system configuration of CC-Link can also be detected by either of the following operations.
• Click the [Detect Now] button in the "CC-Link Configuration" window.
• Select [Online]  [Detect Now] in MELSOFT Navigator.
For the operation methods of MELSOFT Navigator, refer to the following manual.
(Let's start iQ Works Version 2)
4 CC-Link
58
4.1 Detecting Devices Supporting iQSS Automatically