Table of Contents
Advertisement
Data backup
Information of a device supporting iQSS can be saved in an SD memory card for each ID by using an engineering tool.
Operating procedure
2. Select
1. Select
The initial values of the backup setting (SD1438 and SD1444) are as follows:
• SD1438 (Folder number setting): FFFFH (automatic specification)
• Lower 8 bits of SD1444 (operation setting on error): 0H (continue)
Use a program when backing up data with the settings other than the one above. (Page 38 Program
execution for data backup)
■Other methods of data backup
Data can be backed up by the following methods.
• Select a target module in the 'List of modules' or 'Device map area' in the "AnyWireASLINK Configuration" window, then
right-click and select [Backup Slave Module] from the shortcut menu.
• Select a target module in the 'List of modules' or 'Device map area' on the "Sensor/Device Monitor for AnyWireASLINK"
screen, then right-click and select [Backup Slave Module] from the shortcut menu.
1.
Select a target device supporting iQSS in 'List of modules' or
'Device map area' in the "AnyWireASLINK Configuration"
window, and select [AnyWireASLINK Configuration]
[Online] [Backup Slave Module].
2.
Read the message, and click the [Yes] or [OK] button.
Data is backed up.
3.5 Backing up/Restoring Data of Devices Supporting iQSS
3 AnyWireASLINK
37
3
Advertisement
Table of Contents
