Mitsubishi Electric IQSS-R-E Reference Manual page 283

• Up to 16 devices supporting iQSS can be displayed in the "Ethernet Configuration" window (in ascending
order of MAC address) by performing an automatic detection of connected devices.
• The system configuration cannot be detected if an error occurs on a CPU module or device supporting
iQSS.
Take the corrective actions and perform the automatic detection function of connected devices again.
• Error information is displayed in the "Output" window when an error occurred.
Double-click it and correct the error at the jumped destination.
• When a module which is not a device supporting iQSS is detected, it is displayed as shown below:
"Module with No Profile Found"
"General Module"
■All connected devices supporting iQSS are not detected
If all devices supporting iQSS are not detected, remove the following error factors and perform an automatic detection of
connected devices again.
• The Ethernet line is overloaded due to another function of a CPU module being performed.
• The communication cannot be established due to a reason such as a disconnection of an Ethernet cable.
• An error occurred in the following functions.
• Simple PLC communication function
• Socket communication function
• Time setting function (SNTP client)
• Data logging file transfer function
• File transfer function (FTP client)
• Predefined protocol support function
• SP.READ instruction, SP.WRITE instruction
Available functions differ depending on the CPU module used. For details, refer to the user's manual of a CPU module used.
10.1 Detecting Devices Supporting iQSS Automatically
10
10 Ethernet
281