Mitsubishi Electric IQSS-R-E Reference Manual page 314

Information may not be read correctly when performing an automatic detection of connected devices right
after a slave station is connected. In that case, perform an automatic detection of connected devices again.
When the "User Authentication" screen appears, enter the user name and the password of a MELIPC.
Detected devices to be displayed in the CC IE Field Configuration window
Modules detected after performing an automatic detection of connected devices are displayed differently depending on
whether a profile has been registered.
■A profile has been registered
• The module model names are displayed in "Model Name".
• "Local Station", "Intelligent Device Station", "Remote Device Station", or "Remote I/O Station" is displayed in the column of
"Station Type".
■A profile has not been registered
• The module model names, "General Local Station", "Gen. Intelligent Device Station", "General Remote Device Station", or
"General Remote I/O Station" is displayed in the column of "Model Name".
• "Local Station", "Sub-Master Station", "Intelligent Device Station", "Remote Device Station", or "Remote I/O Station" is
displayed in the column of "Station Type".
When using the versions of modules that do not support an automatic detection of connected devices, the
information will not be displayed properly in the column of "Model Name" and "Station Type", even though a
profile has been registered.
A reserved station and a data link faulty station cannot be detected by the automatic detection function of
connected devices.
11 CC-Link IE Field Network
312
11.1 Detecting Devices Supporting iQSS Automatically
The actual system configuration is displayed in the "CC IE Field
Configuration" window.
5.
Select [Close with Reflecting the Setting] in the "CC IE Field
Configuration" window.
Information such as parameters displayed in the "CC IE Field
Configuration" window is applied to the network parameter.