Mitsubishi Electric IQSS-R-E Reference Manual page 201

• Once an automatic detection of connected devices is performed, the mode setting and the transmission rate
which have been set in a CC-Link master/local module are also detected.
• The system configuration cannot be detected if an error occurs on the master station.
Take the corrective actions and perform an automatic detection of connected devices again.
• Error information is displayed in the "Output" window when an error occurred.
Double-click it and correct the error at the jumped destination.
• When a module which is not a device supporting iQSS is detected, it is displayed as shown below:
"Module with No Profile Found"
"General Module"
• When "Module with No Profile Found" is displayed, it can be changed to "General CC-Link Module" by the
following operation:
Select the target module, and select [CC-Link Configuration]  [Change Module]  [Change to General
CC-Link Module].
The "CC-Link Configuration" window appears.
4.
Click the [Detect Now] button.
5.
Read the message and select the "Set the Module
Connected to the Communication Module also as the Read
Object" checkbox, then click the [Yes] button.
The actual system configuration is displayed in the "CC-Link
Configuration" window.
6.
Select [Close with Reflecting the Setting] in the "CC-Link
Configuration" window.
The information, such as parameters, displayed in the "CC-Link
Configuration" window is applied to the network parameter.
8.1 Detecting Devices Supporting iQSS Automatically
8
8 CC-Link
199