Firmware Version 4.7; A.1.3 Firmware Version 4.7 - Siemens Sinamics G110M Operating Instructions Manual

A.1.3

Firmware version 4.7

Table A- 4 New functions and function changes in Firmware 4.7
Function
1 Supporting the identification & maintenance datasets (I&M1 ... 4)
2 Fall in pulse rate with increased drive power required by the motor
The inverter temporarily lowers the pulse frequency if required when the
•
motor is started up, and simultaneously increases the current limit.
3 S7 communication
Direct data exchange between the inverter and human-machine interface
•
(HMI).
Increase in communication performance with the engineering tools and
•
support of the S7 routing
4 The basic functions of Safety Integrated are unrestrictedly available in all con-
trol types with 1FK7 encoderless permanent-field synchronous motors
5 Encoderless 1FK7 synchronous motors are supported
Direct motor selection based on the article number with associated code
•
number
It is not necessary to input individual motor data
•
6 Pulse input as source of setpoint value
The inverter calculates its speed setpoint from a sequence of pulses at the
•
digital input.
7 Dynamic IP address assignment (DHCP) and temporary device names for
PROFINET
8 PROFIenergy Slave profile 2 and 3
9 Uniform behavior for component replacement
After a component is replaced, an inverter with activated Safety Integrated
•
will report what type of component has been replaced using a unique code.
10 Improved direct-component control in PM230
Optimized efficiency for pump and fan applications
•
11 Rounding down of BACnet and macros
Distributed converter for SIMOGEAR geared motors
Operating Instructions, 09/2017, FW V4.7.9, A5E31298649B AH
A.1 New and extended functions
SINAMICS
G120
✓ ✓ ✓ ✓ ✓ ✓
✓ ✓ ✓ ✓ ✓ ✓
✓ ✓ ✓ ✓ ✓ ✓
- - - - - -
- - - - - -
- - - - - ✓
✓ ✓ ✓ - ✓ ✓
✓ ✓ ✓ - ✓ ✓
✓ ✓ - - ✓ ✓
- - ✓ - - -
- - ✓ - - -
Appendix
G120D
✓ ✓
✓ ✓
✓ ✓
✓ -
✓ -
- -
✓ ✓
✓ ✓
✓ ✓
- -
- -
353