Restoring The Factory Settings - Siemens Sinamics G110M Operating Instructions Manual

Commissioning

5.5 Restoring the factory settings

4. Switch on the motor.
The inverter starts the motor data identification. This measurement can take several
minutes.
Depending on the setting, after motor data identification has been completed, the inverter
switches off the motor - or it accelerates it to the currently set setpoint.
5. If required, switch off the motor.
6. Relinquish the master control after the motor data identification.
7. Press button
You have completed the motor data identification.
5.5 Restoring the factory settings
When must you reset the inverter to the factory settings?
Reset the inverter to the factory settings in the following cases:
● The line voltage was interrupted during commissioning and you were not able to complete
commissioning.
● You can no longer trace the settings that you made during commissioning.
● You do not know whether the inverter was already operational.
Restoring the factory settings when the safety functions are enabled
If you are using the integrated safety functions of the inverter, e.g. "Safe Torque Off", you
must reset the safety functions separately from the remaining inverter settings.
The settings of the safety functions are protected by a password.
Settings that are not changed when restoring the factory setting
The communication settings and the settings of the motor standard (IEC/NEMA) are kept
when restoring the factory setting.
134
(RAM to ROM).
Operating Instructions, 09/2017, FW V4.7.9, A5E31298649B AH
Distributed converter for SIMOGEAR geared motors