Siemens Sinamics G110M Operating Instructions Manual page 35

Table 3- 4 Description and location of interfaces
Item Description
Power Module
Interface cover
Communications port 1
Digital input 2 and digital input 3
Communications port 2
Digital output 0 and digital output 1
Analog input 0 and analog input 1
External 24 Vdc OUT
External 24 Vdc IN
Digital input 0 and digital input 1
Mains supply connection
Terminal housing
Distributed converter for SIMOGEAR geared motors
Operating Instructions, 09/2017, FW V4.7.9, A5E31298649B AH
3.3 General layout SINAMICS G110M system
Item Description
Blanking plate - to seal the opposite side of the Terminal
Housing from which the CPI has been fitted.
Cable gland or HANQ connections for left-side mounting
or daisy chaining the mains supply
Potentiometer
Optical I/O connection
Mini USB connection
Memory card reader
Braking resistor & motor connection terminals
Communications & Power Interface (CPI) interface ribbon
cable
PROFIBUS/USS address and commissioning DIP
switches 1 and 2
EM Brake & mains supply connection terminals
Control Module (CM)
PROFIBUS/PROFINET/USS communications cable
Description
35