Manually Transferring The Settings From The Memory Card - Siemens Sinamics G110M Operating Instructions Manual

3. Ensure the application under the control of the converter is in a safe state.
4. Remove the Power Module from the Terminal Housing.
5. Insert the memory card, containing the parameter set data into the memory card reader.
6. Fit the Power Module to the Terminal Housing - making sure that the seals are fitted
correctly and the correct tighten torque (2.0 Nm) is used to ensure the IP rating of the
Inverter.
7. Reconnect the mains supply and the external 24 V supply to the system.
8. On power-up the converter will automatically read the default parameter set data into the
converters memory.
7.1.3

Manually transferring the settings from the memory card

Procedure: Manual data transfer from a memory card
1. All mains supply and the 24 V external supply.
2. Wait 5 minutes to ensure that any residual
power in the system as dissipated.
3. Ensure the application under the control of the
converter is in a safe state.
4. Remove the Power Module from the Terminal
Housing.
5. Insert a blank formatted memory card into the
memory card reader.
6. Fit the Power Module to the Terminal Housing -
making sure that the seals are fitted correctly
and the correct tighten torque (2.0 Nm) is used
to ensure the IP rating of the Inverter.
7. Reconnect the mains supply and the external
24 V supply to the system.
8. Follow the procedure outlined below to transfer
the converters parameters to the memory card,
using STARTER.
Procedure with STARTER
Proceed as follows to transfer settings from a memory card to the inverter:
1. Go online and in your drive, select the "Drive Navigator".
2. Select the "Commissioning" button.
3. Select the button to transfer the data from the memory card to the inverter.
Distributed converter for SIMOGEAR geared motors
Operating Instructions, 09/2017, FW V4.7.9, A5E31298649B AH
Data backup and series commissioning
7.1 Backing up and transferring settings using memory card
287