Advanced Commissioning; Overview Of Converter Functions - Siemens Sinamics G110M Operating Instructions Manual

Advanced commissioning

6.1

Overview of converter functions

Figure 6-1 Overview of converter functions
Drive control
The inverter receives its commands from the higher-level control via the terminal strip or the
fieldbus interface of the Control Unit. The drive control defines how the inverter responds to
the commands.
The inverter can switch between different settings of the drive control.
The inverter can control a motor holding brake. The motor holding brake holds the motor in
position when it is switched off.
Distributed converter for SIMOGEAR geared motors
Operating Instructions, 09/2017, FW V4.7.9, A5E31298649B AH
Sequence control when switching the motor on and off (Page 142)
Adapt the default setting of the inputs and outputs (Page 143)
Drive control via PROFIBUS or PROFINET (Page 149)
Control via AS-i (Page 165)
Jogging (Page 176)
Limit position control (Page 177)
Quick Stop function (Page 180)
Switching over the drive control (command data set) (Page 183)
6
139