Siemens Sinamics G110M Operating Instructions Manual page 285

Automatic upload
The inverter power supply has been switched off.
1. Insert an empty memory card into the card reader of the Power Module.
2. Fit the Power Module to the Terminal Housing - making sure that the seals are fitted
correctly and the correct tighten torque (2.0 Nm) is used to ensure the IP rating of the
Inverter.
3. Connect the external 24 V supply to the External Interface Module (EIM).
After the Control Unit has been powered-up, the Inverter copies all modified parameters to
the memory card.
Note
If the memory card is not empty and already contains parameter settings, the Inverter will
take the parameter settings from the memory card. The previous setting in the Inverter will
be deleted.
Manual upload
To manually upload the parameter settings, you will need to transfer the data to the memory
card as follows:
1. Disconnect the mains supply and the 24 V external supply.
2. Wait 5 minutes to ensure that any residual power in the system as dissipated.
3. Ensure the application under the control of the converter is in a safe state.
4. Remove the Power Module from the Terminal Housing.
5. Insert the memory card into the memory card reader.
6. Fit the Power Module to the Terminal Housing - making sure that the seals are fitted
correctly and the correct tighten torque (2.0 Nm) is used to ensure the IP rating of the
Inverter.
7. Reconnect the mains supply and the external 24 V supply to the system.
Procedure with STARTER
Proceed as follows to back up your settings on a memory card:
1. Go online.
2. Press the "Copy RAM to ROM" button
Distributed converter for SIMOGEAR geared motors
Operating Instructions, 09/2017, FW V4.7.9, A5E31298649B AH
Data backup and series commissioning
7.1 Backing up and transferring settings using memory card
.
285