Configuring The Communication Using Simatic S7 Control; Installing The Gsd; Setting The Address - Siemens Sinamics G110M Operating Instructions Manual

4.4.3.3

Configuring the communication using SIMATIC S7 control

● If the inverter is listed in the hardware library of HW-Conifg, you can configure the
communication in the SIMATIC control.
● If the inverter is not listed in the hardware library, you can either install the newest
STARTER or Startdrive version or install the GSD of the inverter via "Extras/GSD-Install
file" in HW-Config.
4.4.3.4

Installing the GSD

Procedure
To load the GSD of the inverter in the control, proceed as follows:
1. Obtain the GSD
– either on the Internet:
– or from your inverter. To do this, insert a memory card into the inverter and set p0804
2. Unzip the GSDfile in a folder on your computer.
3. Import the GSDinto the configuration tool of your control.
You have now installed the GSD file.
4.4.3.5

Setting the address

Valid address range: 1 ... 125
Distributed converter for SIMOGEAR geared motors
Operating Instructions, 09/2017, FW V4.7.9, A5E31298649B AH
GSD (http://support.automation.siemens.com/WW/view/en/22339653/133100)
= 12. In this way, you will save the GSD on the memory card as (DPGSD.ZIP)
compressed file in the directory /SIEMENS/SINAMICS/DATA/CFG .
General layout SINAMICS G110M system (Page 33)
4.4 Connecting the inverter to the fieldbus
You set the PROFIBUS address of the inverter using
the address switch on the Control Unit, in parameter
p0918 or in STARTER.
In parameter p0918 (factory setting: 126) or in
STARTER, you can only set the address, if all address
switches are set to "OFF" (0) or "ON" (1).
If you have specified a valid address with the address
switches, this address will always be the one that
takes effect and parameter p0918 cannot be changed.
Installation
95