Basic Commissioning With The Iop-2 - Siemens Sinamics G110M Operating Instructions Manual

5.4.3

Basic commissioning with the IOP-2

Basic commissioning wizard
NOTICE
Requirements prior to using the Basic Commissioning Wizard
• The user must be fully conversant with all safety instructions as detailed in the
• The converter must be installed and checked as per the relevant instructions in the
• Macro source selection: During the basic commissioning process, the user will be
• The information required to be input into the Basic Commissioning Wizard can be found
• If the motor is to operate with the "87 Hz characteristic", you need to connect the motor
• The basic commissioning wizard presents three levels of commissioning, as follows:
Select Wizards
Distributed converter for SIMOGEAR geared motors
Operating Instructions, 09/2017, FW V4.7.9, A5E31298649B AH
"Fundamental Safety Instructions" section of the Operating Instructions for your
converter.
"Installation" sections of the converter Operating Instructions.
presented with a list of preset macros that determine the configuration of converter.
Every Control Unit Operating Instructions contain a list of the macros that are specific for
that particular Control Unit and show the wiring configurations for each macro. For
further information, see the relevant Operating Instructions.
on the motor rating label, an example of which is included in the Operating Instructions
for your converter.
in Delta (Δ), this is shown in the "Installation" section of the Operating Instructions for
your converter.
– Expert Mode - this mode presents the user with a detailed list of all relevant
parameters that require to be configured.
– Standard Drive Control - this mode presents the user with the necessary input
screens for standard applications.
– Dynamic Drive Control - this mode presents the user with the necessary input
screens for more complex applications.
This example shows the commissioning steps using the "Standard Drive Control"
method.
Select required Commission-
ing wizard
Commissioning
5.4 Quick commissioning
Select Factory Reset (yes or
no)
119