Installing A Raid Adapter Remote Battery Or Flash Power Module In The Server - Lenovo x3300 M4 7382 Installation And Service Manual

6. Locate the ServeRAID adapter which you will install the memory module. Remove the ServeRAID
adapter if necessary.
7. Touch the static-protective package that contains the adapter to any unpainted metal surface on the
server; then, remove the adapter from the package.
8. Align the memory module with the connector on the ServeRAID adapter and push it into the connector
until it is firmly seated.
9. Reinstall the ServeRAID adapter (see "Installing an adapter" on page 61).
10. Install and lock the left-side cover (see "Replacing the left-side cover" on page 88).
11. Reconnect the external cables and power cords; then, turn on the attached devices and turn on the
server.
If you have other devices to install or remove, do so now. Otherwise, go to "Completing the installation" on
page 85.
Installing a RAID adapter remote battery or flash power module in the
server
Use this information to install a RAID adapter remote battery or flash power module into the server.
When you install any RAID adapter that comes with batteries, it is sometimes necessary to install the
batteries in another location in the server to prevent the batteries from overheating.
To install a RAID adapter remote battery in the server, complete the following steps:
1. Read the safety information that begins in "Safety" on page v and "Installation guidelines" on page 36.
2. Turn off the server (see "Turning off the server" on page 24) and all attached peripheral devices.
Disconnect all power cords; then, disconnect all external cables from the server.
3. Carefully turn the server on its side so that it is lying flat, with the cover facing up.
Attention: Do not allow the server to fall over.
4. Unlock and remove the left-side cover (see "Removing the left-side cover" on page 39)
5. See the documentation that comes with the adapter for any cabling instructions and information about
jumper or switch settings. (It might be easier for you to route cables before you install the adapter.)
6. Install the ServeRAID adapter on the system board (see "Installing an adapter" on page 61)
7. Connect one end of the battery cable to the RAID adapter battery connector.
68
System x3300 M4 Installation and Service Guide