Lenovo x3300 M4 7382 Installation And Service Manual page 36

• If a power failure occurs while the server is turned on, the server will restart automatically when power is
restored.
• If your operating system supports the Wake on LAN feature, the Wake on LAN feature can turn on the
server.
Notes:
1. When 4 GB or more of memory (physical or logical) is installed, some memory is reserved for various
system resources and is unavailable to the operating system. The amount of memory that is reserved for
system resources depends on the operating system, the configuration of the server, and the configured
PCI options.
2. Ethernet 1 connector supports Wake on LAN feature.
3. When you turn on the server with external graphical adapters installed, the Lenovo logo displays on the
screen after approximately 3 minutes. This is normal operation while the system loads.
4. Make sure the left-side cover is closed.
Turning off the server
Use this information to turn off the server.
When you turn off the server and leave it connected to ac power, the server can respond to requests to the
service processor, such as a remote request to turn on the server. While the server remains connected to ac
power, one or more fans might continue to run. To remove all power from the server, you must disconnect it
from the power source.
Some operating systems require an orderly shutdown before you turn off the server. See your operating-
system documentation for information about shutting down the operating system.
Statement 5
CAUTION:
The power control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
The server can be turned off in any of the following ways:
• You can turn off the server from the operating system, if your operating system supports this feature. After
an orderly shutdown of the operating system, the server will turn off automatically.
• You can press the power-control button to start an orderly shutdown of the operating system and turn off
the server, if your operating system supports this feature.
24
System x3300 M4 Installation and Service Guide