Starting The Lsi Configuration Utility Program - Lenovo x3300 M4 7382 Installation And Service Manual

Table 16. Server configuration and applications for configuring and managing RAID arrays (continued)
Server configuration
ServeRAID-M5110, ServeRAID-
M5120 adapters
ServeRAID-C105
Notes:
1. For more information about Problem Determination and Service Guide for ServeRAID M controllers, see
http://www-947.ibm.com/support/entry/portal/docdisplay?lndocid=MIGR-5085607
2. For more information about Configuration and Options Guide (COG), see
support/entry/portal/docdisplay?lndocid=SCOD-3ZVQ5W&brandind=5000019
3. For further details on creating a software RAID array of hard disk drives, please see the ServeRAID C105
documentation at
http://www-947.ibm.com/support/entry/portal/docdisplay?lndocid=MIGR-5089068

Starting the LSI Configuration Utility program

Use these instructions to start the LSI Configuration Utility program.
To start the LSI Configuration Utility program, complete the following steps:
1. Turn on the server, and make sure that the server is the owner of the keyboard, video, and mouse.
2. When the prompt message is displayed, you may perform either of the following:
a. ServeRAID-H1110: press Ctrl+C.
b. ServeRAID-M5110, ServeRAID-M5120, or ServeRAID-M1115: press Ctrl+H.
When you have finished changing settings, press Esc to exit from the program; select Save to save the
settings that you have changed.
Starting the Human Interface Infrastructure (HII) Configuration Application
Use these instructions to start the Human Interface Infrastructure (HII) configuration utility program.
To start the Human Interface Infrastructure (HII) configuration utility program, complete the following steps:
1. Turn on the server.
Note: Approximately 1 to 3 minutes after the server is connected to ac power, the power-control button
becomes active after the power-on LED flashes slowly.
2. When prompted, <F1 Setup> is displayed, press F1. If you have set an administrator password, you are
prompted to type the password.
3. Under System Settings, select Storage.
When you have finished changing settings, press Esc to exit from the program; select Save to save the
settings that you have changed.
Creating RAID of hard disk drives (ServeRAID-C105 only)
These instructions are used for creating RAID of hard disk drives (ServeRAID-C105 only).
Notes:
108
System x3300 M4 Installation and Service Guide
RAID array configuration (before
operating system is installed)
MegaRAID BIOS Configuration Utility
(press Ctrl+H to start), pre-boot CLI
(press Ctrl+P to start), ServerGuide,
HII
HII
RAID array management (after
operating system is installed)
MegaRAID Storage Manager (MSM),
MegaCLI, and Lenovo Director
MegaRAID Storage Manager (MSM),
MegaCLI
.
http://www-947.ibm.com/
.
.