Lenovo x3300 M4 7382 Installation And Service Manual page 228

4. Remove the left-side cover (see "Removing the left-side cover" on page 193.
5. Remove the fillers if necessary.
6. Install the 2.5-inch hard disk drive cage if necessary.
Note: If you are upgrading the hard disk drive bays from 16 to 24 and the 2.5-inch hard disk drive cage
is already installed. Keep the new 2.5-inch hard disk drive cage comes with the option in a safe place for
potential future use.
a. Align the 2.5-inch hard disk drive cage with the chassis and install it in the server.
b. Fasten the four screws.
7. Install the 2.5-inch hot-swap hard disk drive backplane (see "Replacing a 2.5-inch disk drive backplane"
on page 243).
8. Install the EMC shields that come with the option.
9. Install the 2.5-inch hard disk drives (see "Installing a 2.5-inch hot-swap hard disk drive" on page 53).
10. Install the drive bay filler panels that come with the option into empty drive bays.
11. Connect the backplane configuration cable, power cable, signal cable, and the configuration cable (see
"Internal Cable Routing and Connectors" on page 172).
Note: You may need to install the two screws on the backplane configuration cable.
216
System x3300 M4 Installation and Service Guide