Lenovo x3300 M4 7382 Installation And Service Manual page 227

12. Connect power and signal cables to the drive and the connectors on the system board (see "Internal
Cable Routing and Connectors" on page 172).
If you have other devices to install or remove, do so now. Otherwise, go to "Completing the installation" on
page 85.
Replacing a SAS/SATA HDD option
Use this information to replace a SAS/SATA HDD.
Note: You must turn off the server before replacing a SAS/SATA 8 Pac HDD option.
To remove a SAS/SATA 8 Pac HDD option, complete the following steps:
Step 1. Read the safety information that begins in "Safety" on page v and "Installation guidelines" on page
169.
Step 2. Turn off the server and peripheral devices, and disconnect the power cords and all external cables.
Step 3. Remove the bezel (see "Removing the bezel" on page 191).
Step 4. Remove the left-side cover (see "Removing the left-side cover" on page 193).
Step 5. Pull the hard disk drives and filler panels out of the server slightly to disengage them from the hard
disk drive backplane.
Step 6. Remove the 2.5-inch hot-swap SAS/SATA hard disk drive backplane (see "Replacing a 2.5-inch
disk drive backplane" on page 243).
You can install an Lenovo System x3300 M4 Hot-swap SAS/SATA 8 Pac HDD option in the server. See
www.lenovo.com/ serverproven/
option, contact your Lenovo marketing representative or authorized reseller.
To install a SAS/SATA 8 Pac HDD option, complete the following steps:
1. Read the safety information that begins in "Safety" on page v and "Installation guidelines" on page 169.
2. Turn off the server and peripheral devices, and disconnect the power cords and all external cables.
3. Remove the bezel (see "Removing the bezel" on page 191.
for a list of supported optional devices. To order a SAS/SATA 8 Pac HDD
.
Chapter 6 Removing and replacing components
http://
215