Lenovo x3300 M4 7382 Installation And Service Manual page 666

4. Check IBM support site for an applicable service bulletin or firmware update that applies to this
error.
5. Reflash IMM Firmware.
6. Remove and re-install CMOS battery for 30 seconds to clear CMOS contents.
7. Trained Service technician only) Replace the system board.
• W.3818005 [W.3818005] The CRTM flash driver could not successfully flash the staging area. The
update was aborted
Explanation: CRTM Update Aborted
Severity
Warning
User Response
Complete the following steps:
1. Continue booting system. If system does not reset, manually reset the system.
2. If the error is not reported on the subsequent boot, no additional recovery action is required.
3. If the event persists, continue booting system and reflash UEFI image.
4. (Trained service technician only) Replace the system board.
• W.3868001 [W.3868001] BOFM: Reset loop avoided - Multiple resets not allowed.
Explanation: BOFM: Reset loop avoided - Multiple resets not allowed
Severity
Warning
User Response
Complete the following steps:
1. Update all firmware (including adapter firmware) to the latest levels.
2. If problem persists escalate to the next level of support.
• W.3868002 [W.3868002] BOFM: Error communicating with the IMM - BOFM may not be deployed
correctly.
Explanation: BOFM: Error communicating with the IMM - BOFM may not be deployed correctly
Severity
Error
User Response
Complete the following steps:
1. Update all firmware (including adapter firmware) to the latest levels.
2. If problem persists escalate to the next level of support.
• W.3938002 [W.3938002] A boot configuration error has been detected.
Explanation: Boot Configuration Error
Severity
Warning
User Response
Complete the following steps:
1. F1 Setup -> Save Settings
2. Retry OOB config update
• W.50001 [W.50001] A DIMM has been disabled due to an error detected during POST.
654
System x3300 M4 Installation and Service Guide