Returning A Device Or Component; Internal Cable Routing And Connectors - Lenovo x3300 M4 7382 Installation And Service Manual

• Remove the device from its package and install it directly into the server without setting down the device.
If it is necessary to set down the device, put it back into its static-protective package. Do not place the
device on the server cover or on a metal surface.
• Take additional care when handling devices during cold weather. Heating reduces indoor humidity and
increases static electricity.

Returning a device or component

If you are instructed to return a device or component, follow all packaging instructions, and use any
packaging materials for shipping that are supplied to you.

Internal Cable Routing and Connectors

This section contains information about the internal cable routing and connectors.
The server uses cables to connect SATA attached, hot-swap SATA, hot-swap SAS and DVD drive devices to
the power supply and to the system board.
Review the following information before connecting power and signal cables to internal drives:
• The drives that are preinstalled in the server come with power and signal cables attached. If you replace
any drives, remember which cable is attached to which drive.
• When you route a cable, make sure that it does not block the airflow to the rear of the drives or over the
microprocessor or DIMMs.
Power Cable Connection
This section contains information about the power cable connection.
The following illustration shows the fixed power cable routing.
172
System x3300 M4 Installation and Service Guide