Table of Contents
Advertisement
Note: The positioning of the remote battery depends on the type of the remote batteries that you
install.
b. Connect the other end of the battery cable to the battery cable connector on the battery.
c. Lower and press down on the retention clip until it snaps in place to hold the battery firmly in place.
If you have other devices to install or remove, do so now. Otherwise, go to "Completing the installation" on
page 85.
Removing an optional ServeRAID adapter memory module
Use this information to remove an optional ServeRAID adapter memory module.
To remove an optional ServeRAID adapter memory module, complete the following steps:
1. Read the safety information that begins in "Safety" on page v and "Installation guidelines" on page 169.
2. Turn off the server (see "Turning off the server" on page 24) and all attached peripheral devices.
3. Disconnect all power cords; then, disconnect all external cables from the server.
4. Carefully turn the server on its side so that it is lying flat, with the cover facing up.
Attention: Do not allow the server to fall over.
5. Unlock and remove the left-side cover (see "Removing the left-side cover" on page 193).
6. See the documentation that comes with the adapter for any cabling instructions and information about
jumper or switch settings. It might be easier for you to route cables before you install the adapter.
7. Remove the adapter (see "Removing an adapter" on page 217).
8. Grasp the memory module and lift to remove it from the connector on the ServeRAID adapter.
228
System x3300 M4 Installation and Service Guide
Advertisement
Table of Contents
Troubleshooting
