Lenovo x3300 M4 7382 Installation And Service Manual page 663

Error
User Response
Complete the following steps:
1. If the Processor or firmware was just updated, check IBM support site for an applicable service
bulletin or firmware update that applies to this Processor error.
2. (Trained service technician only) If there are multiple Processor's, swap Processor's to move
affected Processor to another Processor socket and retry. If problem follows the affected
Processor, or this is a single Processor system, replace the Processor. Inspect Processor socket
on each Processor removal and replace system board first if damaged or mis-aligned pins are
found.
3. (Trained Service technician only) Replace the system board.
• W.3048006 [W.3048006] UEFI has booted from the backup flash bank due to an Automatic Boot
Recovery (ABR) event.
Explanation: Automated Boot Recovery, Booting Backup UEFI Image
Severity
Warning
User Response
Complete the following steps:
1. Check IBM support site for an applicable service bulletin or firmware update that applies to this
error.
2. Reflash Primary UEFI image. Refer to UEFI Recovery section of service information for this
product.
3. (Trained service technician only) Replace the system board.
• W.305000A [W.305000A] An invalid date and time have been detected.
Explanation: RTC Date and Time Incorrect
Severity
Warning
User Response
Complete the following steps:
1. Check IMM/chassis event log. This event should immediately precede 0068002 error. Service
that event or any other battery related errors.
2. Use F1 Setup to reset date and time. If problem returns after a system reset, replace CMOS
battery.
3. If problem persists then check IBM support site for an applicable service bulletin or firmware
update that applies to this error.
4. Trained Service technician only) Replace the system board.
• W.3058009 [W.3058009] DRIVER HEALTH PROTOCOL: Missing Configuraiton. Requires Change
Settings From F1.
Explanation: DRIVER HEALTH PROTOCOL: Missing Configuration. Requires Change Settings From F1
Severity
Warning
User Response
Complete the following steps:
1. Go to System Settings > Settings > Driver Health Status List and find a driver/controller reporting
Configuration Required status.
Appendix B. UEFI/POST diagnostic codes
651