Installing The Microprocessor 2 Expansion Board - Lenovo x3300 M4 7382 Installation And Service Manual

Note: The positioning of the remote battery depends on the type of the remote batteries that you
install.
b. Connect the other end of the battery cable to the battery cable connector on the battery.
c. Lower and press down on the retention clip until it snaps in place to hold the battery firmly in place.
If you have other devices to install or remove, do so now. Otherwise, go to "Completing the installation" on
page 85.

Installing the microprocessor 2 expansion board

Use this information to install the microprocessor 2 expansion board into the server.
To install the microprocessor 2 expansion board, complete the following steps:
Notes: While installing 16 GB 1.5 Volt/ 32 GB 1.35 Volt, please refers to the table of fan configuration
instruction.
Table 15. Fan Configuration Instruction
Fans Conditions
2 and Standard for all systems
Rear
fan
3
1. When the second microprocessor is populated, the fan is included in the second
microprocessor kit, P/N: 00D2581 ~ 00D2589. Or
2. When more than 2 PCI-e adapters have been installed on the system, the fan (P/N:
00D2593) will be available separately.
1 Optional redundant fan (P/N: 00D2593)
Attention: When fan 3 is installed and 16 GB 1.5V / 32 GB 1.35V DIMMs are installed, fan 1
must also be populated.
70
System x3300 M4 Installation and Service Guide