Lenovo x3300 M4 7382 Installation And Service Manual page 116

To start using the embedded hypervisor functions, you must add the USB flash device to the startup
sequence in the Setup utility.
To add the USB flash device to the startup sequence, complete the following steps:
Step 1. Turn on the server.
Note: Approximately 1 to 3 minutes after the server is connected to ac power, the power-control
button becomes active.
When the prompt <F1> Setup is displayed, press F1.
Step 2.
Step 3. From the Setup utility main menu, select Boot Manager.
Step 4. Select Add Boot Option; then, select USB Storage. Press Enter, and then select Esc.
Step 5. Select Change Boot Order and then select Commit Changes; then, press Enter.
Step 6. Select Save Settings and then select Exit Setup.
If the embedded hypervisor flash device image becomes corrupt, you can use the VMware Recovery CD that
comes with the system to recover the flash device image. To recover the flash device image, complete the
following steps:
1. Turn on the server.
Note: Approximately 1 to 3 minutes after the server is connected to ac power, the power-control button
becomes active.
2. Insert the VMware Recovery CD into the CD or DVD drive.
3. Follow the instructions on the screen.
104
System x3300 M4 Installation and Service Guide