Lenovo x3300 M4 7382 Installation And Service Manual page 225

12. Connect power and signal cables to the drive and the connectors on the system board (see "Internal
Cable Routing and Connectors" on page 172).
If you have other devices to install or remove, do so now. Otherwise, go to "Completing the installation" on
page 85.
Removing an optional tape drive
Use this information to remove an optional tape drive.
To remove an optional full-height tape drive, complete the following steps:
1. Read the safety information that begins in "Safety" on page v and "Installation guidelines" on page 169.
2. Turn off the server (see "Turning off the server" on page 24) and all attached peripheral devices.
Disconnect all power cords; then, disconnect all external cables from the server.
3. Unlock and remove the left-side cover (see "Removing the left-side cover" on page 193).
4. Open the bezel (see "Removing the bezel" on page 191).
5. Disconnect power and signal cables to the drive and the connectors on the system board (see "Internal
Cable Routing and Connectors" on page 172).
6. Remove the air baffle if installed (see "Removing the air baffle" on page 195).
7. Remove the fan assembly (see "Removing the fan assembly" on page 267).
8. Pressing the drive rail on the side of the tape drive and grasp the front of tape drive out of the server.
.
Chapter 6 Removing and replacing components
213