For additional information and instructions, see the VMware ESXi Server 31 Embedded Setup Guide at
pubs.vmware.com/vsphere-50/topic/ com.vmware.ICbase/PDF/ vsphere-esxi-vcenter-server-50-installation-
.
setup-guide.pdf
Using the remote presence and blue-screen capture features
The remote presence and blue-screen capture features are integrated functions of the integrated
management module II (IMM2).
The remote presence feature provides the following functions:
• Remotely viewing video with graphics resolutions up to 1280 x 1024 at 75 Hz, regardless of the system
state
• Remotely accessing the server, using the keyboard and mouse from a remote client
• Mapping the CD or DVD drive, diskette drive, and USB flash drive on a remote client, and mapping ISO
and diskette image files as virtual drives that are available for use by the server
• Uploading a diskette image to the IMM memory and mapping it to the server as a virtual drive
The blue-screen capture feature captures the video display contents before the IMM restarts the server when
the IMM detects an operating-system hang condition. A system administrator can use the blue-screen
capture to assist in determining the cause of the hang condition.
For more information on Features on Demand (FoD), including instructions for automating the activation and
installation of the activation key by using ToolsCenter or Lenovo Director, see the Lenovo Features on
Demand User's Guide at
Note: The server may need to be restarted to activate the feature.
Obtaining the IP address for the IMM
Use this information to obtain the IP address for the IMM.
To access the Web interface to use the remote presence feature, you need the IP address of the IMM. You
can obtain the IMM IP address through the Setup utility. The server comes with a default IP address for the
IMM of 192.168.70.125. To locate the IP address, complete the following steps:
Step 1.
Turn on the server.
Note: Approximately 1 to 3 minutes after the server is connected to ac power, the power-control
button becomes active.
When the prompt <F1> Setup is displayed, press F1. (This prompt is displayed on the screen for
Step 2.
only a few seconds. You must press F1 quickly.) If you have set both a power-on password and an
administrator password, you must type the administrator password to access the full Setup utility
menu.
Step 3.
From the Setup utility main menu, select System Settings.
Step 4.
On the next screen, select Integrated Management Module II.
Step 5.
On the next screen, select Network Configuration.
Step 6.
Find the IP address and write it down.
Step 7.
Exit from the Setup utility.
Logging on to the Web interface
Use this information to log on to the web interface.
https://fod.lenovo.com/lkms
under the Help section.
.
Chapter 3
Configuration information and instructions
http://
105