Lenovo x3300 M4 7382 Installation And Service Manual page 653

• I.1800F [I.1800F] A processor family mismatch has been detected for one or more processor
packages.
Explanation: Processors have mismatched Family
Severity
Error
User Response
Complete the following steps:
1. Verify that matching Processors are installed in the correct Processor sockets according to the
service information for this product
2. Check IBM support site for an applicable service bulletin or firmware update that applies to this
Processor error.
3. (Trained Service technician only) Replace the system board.
• I.18010 [I.18010] A processor stepping mismatch has been detected for one or more processor
packages.
Explanation: Processors of the same model have mismatched Stepping ID
Severity
Error
User Response
Complete the following steps:
1. Verify that matching Processors are installed in the correct Processor sockets according to the
service information for this product.
2. Check IBM support site for an applicable service bulletin or firmware update that applies to this
Processor error.
3. (Trained Service technician only) Replace the system board.
• I.2018002 [I.2018002] The device found at Bus % Device % Function % could not be configured due
to resource constraints. The Vendor ID for the device is % and the Device ID is %.
Explanation: OUT_OF_RESOURCES (PCI Option ROM)
Severity
Info
User Response
Complete the following steps:
1. If this PCIe device and/or any attached cables were recently installed, moved, serviced or
upgraded, reseat adapter and any attached cables.
2. Check IBM support site for any applicable service bulletin or UEFI or adapter firmware update
that applies to this error. NOTE: It may be necessary to disable unused option ROMs from UEFI
F1 setup or ASU or using adapter manufacturer utilities so that adapter firmware can be updated.
3. Move card to a different slot. If slot not available or error re-occurs, replace adapter.
4. (Trained Service technician only) If adapter was moved to a different slot and error did not re-
occur, verify that this is not a system limitation and then replace the system board. Also, if this is
not the initial installation and the error persists after adapter replacement, replace system board.
• I.2018003 [I.2018003] A bad option ROM checksum was detected for the device found at Bus %
Device % Function %. The Vendor ID for the device is % and the Device ID is %.
Explanation: ROM CHECKSUM ERROR
Severity
Error
Appendix B. UEFI/POST diagnostic codes
641