Table 1. Server features and specifications
Microprocessor (depending on the
model):
• Support up to two Intel Xeon™ EN
E5-2400 series multi-core
microprocessors with integrated
memory controller (IMC) and Quick
Path Interconnect (QPI)
architecture
• Up to 20 MB Last Level Cache
(LLC)
• One QuickPath Interconnect (QPI)
link speed up to 8 Giga Transfers
(GT) per second
• Three memory channels DDR3 per
microprocessor on the system
board that supports two DIMMs
per channel
Notes:
• Use the Setup utility program to
determine the type and speed of
the microprocessors
• For a list of supported
microprocessors, see
www.lenovo.com/ serverproven/
Fans:
• The server comes standard with
two speed-controlled fans for one-
microprocessor configuration
• Support up to four fans with two
microprocessors installed
(including one redundant fan)
RAID controllers:
• ServeRAID C105 supports up to
eight SATA ports
– support for RAID level 0, 1 and
10
– support 3.5-inch SATA 3TB
HDDs
– support HDD simple-swap and
hot-swap
– support 4 SATA HDDs in default
(can be upgraded to 8 SATA
HDDs via FoD key)
Notes:
6
System x3300 M4 Installation and Service Guide
Memory:
• Slots: 6 DIMM connectors (12
DIMM connectors when the
microprocessor 2 expansion board
is installed
• Minimum: 2 GB
• Maximum: up to 384 GB (when the
microprocessor 2 expansion board
is installed)
– 96 GB using unbuffered DIMMs
(UDIMMs)
– 192 GB using registered
DIMMS (RDIMMs)
– 384 GB using load reduction
DIMMs
• Type:
– 1066, 1333 or 1600 MHz
– Single-rank, Dual-rank or Quad-
rank DDR3
– UDIMM/RDIMM, up to 32 GB
• Support:
– UDIMM: 2 GB, 4 GB, or 8 GB
– RDIMM: 2 GB, 4 GB, 8 GB, 16
GB
http://
.
Environment:
The Lenovo System X3300 compute
node complies with ASHRAE class
A3 specifications.
• Power on:
– Temperature: 5°C - 40°C (41°F -
104°F) up to 950mm (3,117ft)
Above 950m, de-rated
maximum air temperature 1C /
175m
– Humidity, non-condensing: -12°
C dew point (10.4°F) and 8% -
85% relative humidity
– Maximum dew point: 24°C (75°
F)
Drive:
• Diskette: External USB hard disk
drive
• Supported hard disk drive (HDD):
– Four 3.5-inch hot-swap/simple-
swap SATA HDD in default (can
be upgraded to eight 3.5-inch
hot-swap/simple-swap SATA
HDD via FoD key)
– Eight 2.5-inch hot-swap SAS/
SATA HDD in default (can be
upgraded to sixteen 2.5-inch
hot-swap SAS/SATA HDD via
optional hardware upgrade kit)
Attention: As a general
consideration, do not mix standard
512-byte and advanced 4-KB format
drives in the same RAID array
because it might lead to potential
performance issues.
Notes:
• LSI C105 ServeRAID only support
SATA HDD models
• LSI C105 does not support
VMware
• The system board does not
support parallel IDE/ATA interface.
No floppy disk Interface connector
and no embedded floppy disk
drive is supported
Optional SATA optical drives:
• Two Patsburg SATA ports for:
– DVD-ROM
– Multi-Burner (Rambo)
Heat output:
Approximate heat output in British
thermal units (Bts):
• Minimum configuration: 392 Btu
per hour (ac 115 watts)
• Maximum configuration: 2900 Btu
per hour (ac 850 watts)
Integrated functions:
• Integrated Management Module II
(IMM2), which provides service
processor control and monitoring
functions, video controller, and
remote keyboard, video, mouse,
and remote hard disk drive
capabilities