Installing A Pci-X Riser-Card Assembly - Lenovo x3300 M4 7382 Installation And Service Manual

Note: You might find it easier to install the new drive from the front and then attach the cables.
9. Align the rails on the tape drive with the guides in the drive bay; then, slide the tape drive into the drive
bay until the rails click into place.
10. Connect power and signal cables to the drive and the connectors on the system board (see "Internal
Cable Routing and Connectors" on page 172)
If you have other devices to install or remove, do so now. Otherwise, go to "Completing the installation" on
page 85

Installing a PCI-X riser-card assembly

Use this information to install a PCI-X riser-card assembly into the server.
To install a PCI-X riser-card assembly, complete the following steps:
1. Read the safety information that begins in "Safety" on page v and "Installation guidelines" on page 36.
2. Turn off the server (see "Turning off the server" on page 24) and all attached peripheral devices.
Disconnect all power cords; then, disconnect all external cables from the server.
3. Carefully turn the server on its side so that it is lying flat, with the cover facing up.
Attention: Do not allow the server to fall over.
4. Unlock and remove the left-side cover (see "Removing the left-side cover" on page 39
5. Touch the static-protective package that contains the adapter to any unpainted metal surface on the
server; then, remove the adapter from the package.
6. Locate PCI slot 1 which you will install the PCI-X riser-card assembly.
7. Press the latch of the expansion-slot cover kit from the rear side of the server (see step 1 in the following
illustration).
8. Remove the expansion-slot cover kit located in PCI slot 1 and save it for future use. (see step 2 in the
following illustration).
.
Chapter 2 Installing optional devices
59