Table of Contents
Advertisement
4. Unlock and remove the left-side cover (see "Removing the left-side cover" on page 39).
5. Remove the air baffle (see "Removing the air baffle" on page 40) if necessary.
6. Touch the static-protective package that contains the simple-swap fan to any unpainted metal surface
on the server; then, remove the fan from the package.
7. Slide the fan down directly into the server. (see step 1 in the following illustration).
8. Align the release latches of the fan and make sure the fan is firmly seated on the right position. (see step
2 and 3 in the following illustration).
9. Connect the fan power cable on the system board. (see "Internal Cable Routing and Connectors" on
page 172).
If you have other devices to install or remove, do so now. Otherwise, go to "Completing the installation" on
page 85.
Installing a memory module
Use this information to install a memory module into the server.
The following notes describe the types of dual inline memory modules (DIMMs) that the server supports and
other information that you must consider when you install DIMMs (see "System-board internal connectors"
on page 29 for the location of the DIMM connectors):
.
Chapter 2
Installing optional devices
45
Advertisement
Table of Contents
Troubleshooting
