Fan Power Cable Connection
This section contains information on the fan power cable connection.
The following illustration shows the internal cable routing and connectors from the fan assembly to the
system board.
Removing and replacing server components
This section provides information for removing and replacing server components in the server.
Removing and replacing structural parts
This section provides information for removing and replacing structural parts in the server.
Replacement of structural parts is your responsibility. If Lenovo installs a structural part at your request, you
will be charged for the installation.
The illustrations in this document might differ slightly from the hardware.
Removing the bezel
Use this information to remove the bezel from the server.
To remove the bezel, complete the following steps:
Step 1.
Read the safety information that begins in "Safety" on page v and "Installation guidelines" on page
169.
Step 2.
Turn off the server (see "Turning off the server" on page 24) and all attached peripheral devices.
Disconnect all power cords; then, disconnect all external cables as necessary to replace the
device.
.
Chapter 6
Removing and replacing components
191