Lenovo x3300 M4 7382 Installation And Service Manual page 217

If you have other devices to install or remove, do so now. Otherwise, go to "Completing the installation" on
page 85.
Removing a 3.5-inch hot-swap hard disk drive
Use this information to remove a 3.5-inch hot-swap hard disk drive.
Before removing a 3.5-inch hot-swap hard disk drive, read the following information:
• Inspect the drive tray for signs of damage.
• To maintain proper system cooling, do not operate the server for more than 10 minutes without either a
drive or a filler panel installed in each drive bay.
• You do not have to turn off the server to install hot-swap drives in the hot-swap drive bays.
To remove a 3.5-inch hot-swap hard disk drive, complete the following steps.
1. Read the safety information that begins "Safety" on page v and "Installation guidelines" on page 169.
Attention: Static electricity that is released to internal server components when the server is powered-
on might cause the server to halt, which might result in the loss of data. To avoid this potential problem,
always use an electrostatic-discharge wrist strap or other grounding system when you work inside the
server with the power on.
2. Unlock and remove the left-side cover.
Note: You must unlock the left-side cover to open or remove the bezel. When you lock the left-side
cover, it locks both the cover and the bezel.
3. Open the bezel (see "Removing the bezel" on page 191).
4. Remove the filler panel, if one is present.
5. Push the orange release latch of the drive tray and take the 3.5-inch hard disk drive out of the drive bay
of the server.
6. Replace the filler panel into the empty drive bay.
.
Chapter 6 Removing and replacing components
205