Table of Contents
Advertisement
12. Reinstall the bezel (see "Removing the bezel" on page 191).
13. Reinstall the left-side cover (see "Removing the left-side cover" on page 193).
14. Reconnect the power cords and any cables that you removed.
15. Turn on the peripheral devices and the server.
Removing an adapter
Use this information to remove an adapter.
To remove an adapter, complete the following steps:
Step 1.
Read the safety information that begins in "Safety" on page v and "Installation guidelines" on page
169.
Step 2.
Turn off the server (see "Turning off the server" on page 24) and all attached peripheral devices.
Disconnect all power cords; then, disconnect all external cables as necessary to replace the
device.
Step 3.
Carefully turn the server on its side so that it is lying flat, with the cover facing up.
Note: Do not allow the server to fall over.
Step 4.
Unlock and remove the left-side cover (see "Removing the left-side cover" on page 193).
Step 5.
Remove the air baffle (see "Removing the air baffle" on page 195).
Step 6.
Remove the fan assembly (see "Removing the fan assembly" on page 267).
Step 7.
Disconnect any cables from the adapter.
Step 8.
Press down the release latch from the rear of the server to move forward the adapter-retention
brackets to the open position.
.
Chapter 6
Removing and replacing components
217
Advertisement
Table of Contents
Troubleshooting
