Lenovo x3300 M4 7382 Installation And Service Manual page 112

The system-event log contains POST and system management interrupt (SMI) events and all events that
are generated by the baseboard management controller that is embedded in the integrated management
module (IMM).
Important: If the system-error LED on the front of the server is lit but there are no other error indications,
clear the system-event log. Also, after you complete a repair or correct an error, clear the system-event
log to turn off the system-error LED on the front of the server.
– POST Event Viewer
Select this choice to enter the POST event viewer to view the POST event log.
– System Event Log
Select this choice to view the system event log.
– Clear System Event Log
Select this choice to clear the system event log.
• User Security
Select this choice to set, change, or clear passwords. See "Passwords" on page 100 for more information.
This choice is on the full and limited Setup utility menu.
– Power-on Password
Select this choice to set or change a power-on password. See "Power-on password" on page 101 for
more information.
– Administrator Password
Select this choice to set or change an administrator password. An administrator password is intended
to be used by a system administrator; it limits access to the full Setup utility menu. If an administrator
password is set, the full Setup utility menu is available only if you type the administrator password at
the password prompt. For more information, see "Administrator password" on page 101.
• Save Settings
Select this choice to save the changes that you have made in the settings.
• Restore Settings
Select this choice to cancel the changes that you have made in the settings and restore the previous
settings.
• Load Default Settings
Select this choice to cancel the changes that you have made in the settings and restore the factory
settings.
• Exit Setup
Select this choice to exit from the Setup utility. If you have not saved the changes that you have made in
the settings, you are asked whether you want to save the changes or exit without saving them.
Passwords
From the User Security menu choice, you can set, change, and delete a power-on password and an
administrator password.
The User Security choice is on the full Setup utility menu only.
If you set only a power-on password, you must type the power-on password to complete the system startup
and to have access to the full Setup utility menu.
An administrator password is intended to be used by a system administrator; it limits access to the full Setup
utility menu. If you set only an administrator password, you do not have to type a password to complete the
system startup, but you must type the administrator password to access the Setup utility menu.
100
System x3300 M4 Installation and Service Guide