Replacing the left-side cover
Use this information to replace the left-side cover.
To install the server cover, complete the following steps:
Step 1.
Read the safety information that begins in "Safety" on page v and "Installation guidelines" on page
169.
Step 2.
Turn off the server (see "Turning off the server" on page 24) and all attached peripheral devices.
Disconnect all power cords; then, disconnect all external cables as necessary to replace the
device.
Step 3.
Slide the left-side cover over the server until the left-side cover edges slip into position over the
chassis.
Important: Before you slide the left-side cover forward, make sure that all the tabs on the cover
engage the chassis correctly. If all the tabs do not engage the chassis correctly, it will be hard to
remove the cover later.
Step 4.
Lock the left-side cover, using the key that comes with the server.
Replacing the stabilizing feet
Use this information to replace the stabilizing feet.
To replace the server stabilizing feet, complete the following steps:
Step 1.
Read the safety information that begins in "Safety" on page v and "Installation guidelines" on page
169.
Step 2.
Turn off the server and peripheral devices, and disconnect the power cords and all external cables.
Step 3.
Carefully turn the server on its side so that it is lying flat, with the cover facing up.
194
System x3300 M4 Installation and Service Guide