Installing The Remote Access Module - Avaya Remote Access Module 3 User Manual

Page 6 - Installing the Remote Access Module

Installing the Remote Access Module

Page 6
User's Guide
1. Hold the unit against the wall in its intended position. Using the
mounting brackets as a template, mark the position of the fixing
hole on each side. These are approximately 145mm apart
horizontally.
2. Drill and insert two wall plugs and then mount the Remote
Access Module on the wall.
9V DC
3. Connect the serial cable (CAB-RAM) from the units SERIAL
INTERFACE (DTE) socket (25-pin D-type) to one of the INDeX
cabinet's serial ports (9-pin D-types).
– To use the modem link for remote database up and
downloads, you must connect the serial cable to the first
INDeX serial port.
4. Connect the line lead from the unit's LINE socket to the direct
exchange line master socket.
– A dedicated direct exchange line must be used to allow the
unit to operate independent of the INDeX system.
5. Plug the output lead of the Plug Top 9V Power Supply into the
female socket and then connect the plug top into a suitable
mains power outlet. When power is applied, press the Power
Switch on the front of the unit and the MR light on the unit will
illuminate.
SERIAL INTERFACE (DTE)
Remote Access Module 3
38HBK00001SBB – Issue 7 (06/2001)
Installation
Line